Publicidad
Preparation
Bit and Accessory Installation or Removal
• Clean and lubricate lightly the bit and / or accessory
before installing.
• Insert the shaft of the bit into the SDS socket.
• Twist and push the bit in until it engages.
• After installing it, always make sure that the
bit is firmly in place by trying to pull it back out.
• To remove the bit, pull down on the bit sleeve and push the bit out.
WARNING
Do not try to install or remove bits and / or accessories
unless the tool is disconnected.
Start Up
Start up and operation control
• Intermittent Operation:
Connect the plug to the power supply.
Press the switch (A) to start the hammer drill start working.
To stop using, just release the switch.
• Continuous Operation:
Connect the plug to the power supply.
Press the switch (A) and block it by pressing the lock-on button (B).
To interrupt the function press and then release the switch.
Speed Control
• The tool can be operated in different speeds. Select the
speed adjusting the speed control (+ and -) (C) in the
switch.
• Turn the speed control in a clockwise direction to
increase the hammer drill speed and torsion.
• Turn in the opposite direction to diminish speed and
torsion.
• Speed increases depending or the pressure exercised
into the switch (A).
Velocidad
Modo de operación
Alta
Rotomartillo / Cincelado
Media
Taladro
Baja
Rotomartillo / Taladro
C
A
B
Energy
Indicator LED
Material o Uso
Concreto y Piedra
Metal
Iniciar agujeros
7
ENGLISH
Publicidad
