Cherubini Ocean RX Instrucciones página 29

SETTING THE ROTATION DIRECTION OF THE MOTOR
The operation can be performed via remote control or using the white wire.
Every time you perform one of the two sequences below you reverse the output direction
of the motor.
From the remote control:
Tn: Already programmed remote control
+
A B
Tn
From the wired control:
The sequence of this operation is the following:
1) Disconnect the power supply from the motor, via the main switch for example.
2) Connect the white motor wire to the brown wire (phase) or to the blue wire (neutral).
3) Connect the power supply to the motor, which rotates briefly in one direction.
4) Disconnect the power supply from the motor for at least 4 seconds.
5) Connect the motor to the power supply, after about 2 seconds the motor performs a
short rotation up or down. Within 3 seconds disconnect the power supply, for example
using the main switch.
6) Disconnect the white wire from the motor.
2 sec
C
Tn
max 3 sec
29
+
A C
Tn (4 sec)