Bosch HMI 1 270 020 900 Manual Original página 39

OBJ_BUCH-1557-001.book Page 15 Wednesday, September 28, 2011 11:39 AM
Product Description and
Specifications
Technical Data
Battery Charger
Article number
Rated voltage
Frequency
Battery charging
voltage
Charging current
– Normal-charging
operation
– Silent-charging
operation
Allowable charging
temperature range
Charge duration (for
8 Ah battery capacity)
approx.
– Normal-charging
operation
– Silent-charging
operation
Number of battery
cells
Weight according to
EPTA-Procedure
01/2003
Protection class
The values given are valid for a nominal voltage [U] of
230 V. For different voltages and models for specific
countries, these values can vary.
Product Features (see page 6–7)
The numbering of the product features refers to
the illustration of the battery charger on the
graphics page.
14 Rear rack battery
15 Battery charge control indicator
20 Standard battery
23 Battery charger
Bosch eBike Systems
24 Ventilation openings
25 Charger socket
26 Mains voltage selector switch
27 Charger plug
28 Safety warnings, charger
Charger
29 Button for charge operation
0 275 007 900 30 Operation indicator
31 Charge connector
V 115/230
32 Socket for charge connector
Hz 50/60
V= 36
Operation
A 4
A 1
Initial Operation
°C 0...+40
Connecting the Charger (see figures G–H)
Set the voltage of your power source on the
mains voltage selector switch 26 of the charger.
You can select between 115 V and 230 V.
h 2.5
h 8
10–80
Then, insert the charger plug 27 of the power
cord into the charger socket 25 of the charger.
kg 0.8
Connect the mains cable (country-specific) to
/I
the mains supply. The operation indicator 30 on
the charger lights up.
Switch the battery off and remove it from the
holder of the eBike. For this, read and observe
the operating instructions of the battery.
Insert the charge connector 31 of the battery
charger into the socket 32 on the battery. The
operation indicator 30 on the charger flashes.
Place the battery only on clean surfaces.
In particular, avoid contaminating the charge
socket and the contacts, e.g. by means of
sand or ground.
Observe the mains voltage! The voltage of
the power supply must correspond with the
data given on the nameplate of the battery
charger. Battery chargers marked with 230 V
can also be operated with 220 V.
Do not connect the charger to the mains
supply until after the correct mains voltage
has been set on the mains voltage selector
switch 26. Otherwise, the charger can be-
come damaged.
0 276 001 X45 | (28.9.11)
English–15