Publicidad
Drop-in Installation (con't)
Install the unit, inserting the motor/pump end first,
8
lowering the bathtub into the opening as shown in
the illustration.
DO NOT use plumbing fixtures or lines to lower the
unit. Allow the bathtub to rest on the supports.
Inspect all fittings, plumbing, and control lines
9
after inserting to insure the components are not
damaged, disconnected, or contacting the finish
surface substrate or support members.
Connect flex water supply lines to faucet and plug
10
power cords into GFCI outlets.
Remove scrap lumber and lower the bathtub fully
11
into the opening.
Align the bathtub and connect the drain.
12
Turn on the power supply to the dedicated GFCI
13
protected circuits and check system operation.
Caulk around the perimeter of bathtub to seal the
14
space between the rim and the finished deck.
Page 14
All manuals and user guides at all-guides.com
Uneven
Subfloor
www.jacuzzi.com
2˝
(50mm) Max
Thickness
Level Subfloor
Figure 10
Level Subfloor
Figure 11
Figure 12
Comfort Whirlpool Bath
Tile or
Finished
Scrap Lumber
Surface
Substrate
Member Support
Floating
Floor
Compound
Installation and Operation
Publicidad
