Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting with an Ethernet cable
You can connect the console directly to a broadband network using an
Ethernet cable. Refer to the instructions supplied with the network device
for details.
Setup configurations will vary depending on the type of Internet service in
use. Additional network equipment (sold separately) may be required
depending on the network setup. Refer to your Internet service provider or
instructions supplied with the network equipment for details. For
additional information, contact SCEA Consumer Services via our Web site
at http://www.us.playstation.com or call 1-800-345-7669.
1
Insert the Ethernet cable into the network connector on the
console rear.
Console rear
Commercially available Ethernet cable
2
Connect the Ethernet cable to the network device.
The connection method will vary depending on the network device.
Refer to the instructions supplied with the network device for details.
Warning
Do not connect Ethernet cables or telephone cords of the following types to the
network connector. If you connect the wrong type of cable, too much electrical
current may pass through the connector, causing a malfunction, excessive heat
or fire in the connector:
- Ethernet cables not appropriate for use with a 10Base-T/100Base-TX network
- Standard residential telephone lines
- Any ISDN (digital) compatible phone or data line
- PBX phone lines
- Other "unknown" types of telephone lines
Creating a network configuration
After you have connected the console to a network, you will need to create
and save a network configuration. This can be done using PlayStation
format software compatible with the network adaptor (for PlayStation
Refer to the instructions supplied with the software.
Hint
Depending on the type of Internet service used, you may need to provide your MAC
address. You can find the MAC address for your console listed in the Version
Information screen (
page 33).
US
2
®
2).
®
Networking
37
Publicidad
