BlissLights SKY Lite Guia Del Usuario página 5

SETTING UP THE LASER PROJECTOR
Before operating your laser projector, please read the "Before you Begin" section and
1. Remove protective film sticker from laser aperture.
2. Insert the USB power cord into a powered USB port or use the included wall adapter
to connect to an available electrical outlet. It is best practice for users to connect the
power adapter to the wall before connecting the device to the power adapter.
3. Place the Sky® Lite on a flat solid surface and aim toward desired ceiling/wall.
4. Press the power button. The nebula and laser stars will gradually illuminate
and begin moving by default.
5. To adjust the illumination angle for walls, tilt the light forward onto the secondary
support panel.
6. To turn off the light, cycle through the power button modes until the unit turns off
completely. Remove the power plug from electrical outlet.
7. Use the following buttons to control lighting effects:
Top button (effects):
• Power on
• Pulse mode
• Stars only
• Cloud only
• Power off
Middle button (rotation):
• Rotation off
• Rotation on
Bottom button (brightness):
• Normal
• Low
• High
DEFAULT SETTINGS
Once the laser projector is plugged in, it will enter the default mode where all effects are
on. Use the buttons to change the effect settings and brightness. This light has a built-in
timer that is designed to automatically shut off after 6 hours of operation.
"Notice" section of this user's guide.
3