patura P 5000 Manual De Usuario página 47

Montageanleitung / Instructions de montage
Installation Instructions / Montagehandleiding
Indicaciones de montaje
Using the power adaptor and battery leads
The energiser is supplied with a power adaptor (for connection to mains/line power). A set of
battery leads may be purchased as an accessory through your PATURA retailer.
To use the power adaptor:
1. Connect the power adaptor to the power input socket on the rear of the energiser.
2. C onnect the power adaptor to a suitable mains/line power socket, ensuring there is 25 mm of
clear space around the power adaptor.
To remove the power adaptor:
1. Disconnect the power adaptor from the mains/line power.
2. P ull on the white connector to remove the power adaptor plug from the power input socket on
the rear of the energiser.
To use battery leads:
1. I nsert the battery lead into the Power input socket on the rear of the energiser.
2. A ttach the red clip to the positive (+) terminal of the battery, and the black clip to its negative
(-) terminal.
3. N ote: If the energiser is to be used as part of a permanent outdoor installation such as a solar
installation, the battery lead clips should be replaced by permanent battery connectors.
To remove battery leads:
1. Remove the clips from the battery terminals.
2. H old the battery lead by the rubber sleeve at the end of the wire. Pull firmly to remove the
connector from the Power input socket on the rear of the energiser.
47