Descargar Imprimir esta página

Erreka IZAR IZ1C Manual Del Instalador página 32

Ocultar thumbs Ver también para IZAR IZ1C:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

UNPACKING AND INSTALLATION
1
REQUIRED TOOLS
• Set of keys
• Set of screwdrivers
• Spirit level
2
UNPACKING
1 Open the package and carefully remove the
contents from within.
}
Discard the packaging in an environmentally
friendly manner, using recycling containers.
Do not leave the packaging within the reach
of children or handicapped people, as it may
cause injury.
3
INITIAL CONDITIONS AND CHECKS PRIOR TO INSTALLATION
Initial installation conditions
An earthed power supply of 230Vac / 50Hz
(VIVO-D102, VIVO-D103/ADB30, VIVO-D203) or
125Vac / 60Hz (VIVO-D102M, VIVO-D203M) is
required.
Suitability of the devices
Before starting installation:
• Check that the material to be used is in a perfect
condition and suitable for use.
• Ensure that all the devices necessary to guarantee
the safety and operation of the facility are in place.
• Check that all devices to be installed are suitable for
the facility. Pay particular attention to the use limits,
checking the "Technical Characteristics" of all
devices installed. Use only suitable devices.
Risk analysis
• Analyse all possible risks in the facility, taking into
account the essential safety requirements set out in
the Machinery Directive and in applicable standards,
and indicate the solutions chosen.
• Establish the tests to be carried out in accordance
with the risks present, and check that all envisaged
laws, standards and regulations, in particular the
requirements
establishes the test methods, are complied with.
32
Installation Manual
of
Standard
EN 12445,
• Tape measure
• Welding machine
2 Check that the content of the package is complete.
It should include the operator (1a) and the IZ1C,
IZ4C and IZ4DC operators, as well as the chain cover
(1b) (see "Fig. 1 Elements of the complete
installation (up-and-over door)" on page 28). The
rest of the elements are supplied separately.
3 Check the content is in a proper state.
Should it be noticed that a piece is missing or
deteriorated, contact the nearest technical
service.
• Do not modify any part of the automatic device
unless envisaged in this manual. The manufacturer
will not be liable for any damage caused by products
which have been arbitrarily modified.
• Do not allow the devices to be submerged in water
or other liquids. In the event of ingress of water,
disconnect the power supply and contact the
Technical Service.
• Do not place the devices near heat sources or
exposed to flames. Avoid falls and crushing.
Risk analysis is one of the documents which form
part of the automation technical file which must be
filled out by a professional installer.
which

Publicidad

loading

Este manual también es adecuado para:

Izar iz4cIzar izs1Izar izs4Izar izs4dIzar iz4dc