Eldom nevo C530 Manual Del Usuario página 11

• OPERATION
−
The kettle starts working when one of the stored programmes (10) is selected or the
temperature is set.
−
The operation of the appliance can be stopped at any time by switching it off with the by
pressing the button (7).
Preset programmes
− Temperatures: 70°C (White), 80°C (Green), 90°C (Oolong) and 100°C (Boil) are immediately
available by selecting the corresponding button (10).
−
The operation of the appliance is indicated by the illumination of the indicator light of the
selected programme.
−
The jug switches off automatically when the water boils.
−
Operation of the appliance can be interrupted at any time by switching it off using the
button (7).
Manual temperature selection
−
To select the desired water temperature from 40°C - 95°C (in 5°C steps), press the buttons
(9) until the desired value appears on the display (11).
−
After a while, the display (11) will show the current water temperature in the kettle and
heating will start.
−
The operation of the appliance is indicated by the illumination of the controls (7, 8, 9).
The display (11) will show the current temperature.
−
When the set temperature is reached, the kettle will switch off.
−
The operation of the appliance can be stopped at any time by switching it off
−
by pressing the button (7).
Temperature support
−
Temperature maintenance is possible for any selected temperature.
−
To activate the temperature maintenance function, select a temperature and then press
button (8).
−
Activation of the function will be indicated by the blinking indicator (8).
−
After heating the water to the set temperature, the kettle will monitor the temperature for
2 hours - when the water temperature drops below the set value by about 5°C, heating will
resume.
−
Pressing the button (8) without first selecting the temperature will only result in the
indicator light (8) flickering for about 3 seconds.
Note: Removing the kettle from the base erases the settings.
• FILTER
The filter does not remove the scale, but it prevents any deposits from getting inside the kettle while the water
is being poured in. The filter should be cleaned regularly. Hard water may block the filter after boiling water a
couple of times.
• CLEANING AND MAINTENANCE
−
Allow the unit to cool down completely before cleaning.
−
Do not immerse the kettle in water while washing up.
−
The outside of the kettle may be wiped over with a damp cloth and washing-up liquid.
−
Water stains inside the kettle can be removed by rubbing with a cloth moisten with white
vinegar; rinse the inside with water afterwards.
o Limescale should be removed in the following way:
o Fill the kettle with 0.75 litre of water and bring it to boil.
o Switch the kettle off and disconnect the kettle from the power supply.
o Pour 0.1l of vinegar into a jug and leave the solution for a few hours.
o Discard the solution and rinse the inside with water.
o Fill the kettle with 1 litre of water and bring to boil.
o Discard the water and rinse the inside with water.
11