Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 20 Monday, February 20, 2023 9:31 AM
20 INSTALLATION
3
Reinstall the plastic caps.
Sound Insulation Sheet
If your model shipped with a sound insulation
sheet, follow the instructions provided to install
the sheet now. But wait to install the insulation
pad and lower cover until after the final installation
check.
Final Installation Check
Testing the Dishwasher
Check if the dishwasher is properly installed.
1
Turn on the circuit breaker.
2
Turn on the house water supply.
3
Make sure that the door opens and closes
smoothly.
• If necessary, level the dishwasher again.
• If the door will not close, make sure the rack
is level.
• Make sure that all packaging materials have
been removed.
4
Power on the dishwasher and run a 1 Hour
cycle to verify proper operation.
5
Check for leaks at the drain hose and water
supply connection.
6
If a water leak is detected, press and hold the
Start button for 3 seconds to cancel the wash
cycle and automatically drain the water from
the dishwasher. Tighten all water connections
and run another cycle. Repeat until no leaks
are detected.
7
Replace the lower cover.
CAUTION
• Only install the lower cover provided with the
dishwasher. Do not install cabinet baseboard
as it may cause noise and leakage.
8
Remove the protective film from the door, if
present. Leaving the film on may cause
discoloration or condensation on the door.
Installation Check Error Codes
Refer to the chart below before calling for service.
a
Publicidad
