Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions
Preparation
Before using for the first time, boil fresh water at least three
times in the appliance. Use only water without any additives or
ingredients.
Electrical connection
Check whether the electrical voltage that you intend to use is
the same as that of the machine. Details are to be found on the
label on the base.
CAUTION: Overload!
Do not use any multiple sockets, as this device is too power-
ful.
Use
NOTE:
•
Always use fresh water.
•
Do not consume the water if it has been in the kettle for
more than one hour.
•
Also do not constantly reheat cooled water.
•
Always pour out stagnant water.
1. Place the machine on a flat surface.
WARNING:
• Always turn the device off before cleaning it and remove the mains
plug. Wait until the device has cooled down.
• Do not immerse the device in water or other liquids.
CAUTION:
•
Do not use any wire brush or other abrasive objects.
•
Do not use any acidic or abrasive detergents.
•
Rinse the water container out with clean water. Then dry it
off with a cloth.
•
Clean the housing after use with a slightly damp cloth.
Decalcification
•
The frequency of the decalcifying operation depends on
the hardness of the water and on how often the appliance
is used.
•
Please do not use vinegar but a commercially available
decalcification agent on the basis of citric acid. Only use
the quantities stated in the instructions.
2. Open the kettle by pulling the lid upwards.
3. Then fill in the water. The water level should be between
the MIN and MAX marks.
4. Close the lid.
5. Only connect the machine to a properly installed safety
socket.
6. Switch on the kettle by pressing the switch. The control
lamp in the switch will light up.
CAUTION:
After the boiling process, the appliance will not shut off
automatically!
Pausing/ terminating operation
•
Set the switch to the "0" position to pause or terminate the
boiling process.
WARNING: Danger of scalding!
•
When pouring the water out, keep the lid closed.
•
During operation the housing becomes hot. Do not touch
it and allow the device to cool down before storing it
away.
•
Disconnect the power cord.
•
Emptying the water container.
Cleaning
NOTE:
After descaling the device boil fresh water in it several times
(approximately 3-4 times) in order to remove any residues.
Do not consume this water.
• It is not possible to switch the machine on.
Possible Cause:
The appliance has no power supply.
Remedy:
- Check the socket with another appliance.
- Plug in the mains plug correctly.
- Check the main circuit breaker.
Troubleshooting
25
Publicidad
