General Maintenance; Maintenance - Ryobi DUET FPR200 Manual Del Operador

WARNING:
When servicing, use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
fluids entering your eyes resulting in possible serious injury.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, penetrating
oils, etc., come in contact with plastic parts. Chemicals
can damage, weaken or destroy plastic which may result
in serious personal injury.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions.
CAUTION:
It is important to thoroughly clean the sprayer after each
use or when changing colors. Allowing paint or stain to
remain in an idle tool for an extended period can cause
its moving pieces to seize up.
WARNING:
Do not clean with any flammable liquids such as paint
stripper, paint remover, brush cleaner, mineral spirits, lac-
quer thinner, turpentine, acetone, gasoline, kerosene, etc.
CLEANING THE PAINT SYSTEM
See Figures 10 - 12, page 12.
 Set the other switch in the reverse position. This draws the
paint back through the tubes and into the paint can.
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 11 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.

MAINTENANCE

 Squeeze triggers. After one minute, turn the machine off.
 Lift the paint system top and remove the paint can.
Replace the original lid on the paint can.
 Fill a container (not included) with cleaning solution
[i.e, warm water (following the use of latex products) or
Klean-Strip
Klean-Strip
flammable paint thinner (following the use of oil-based
products).
 Place the plastic paint container lid (included) on the
container (not included), then close and latch the paint
system top.
 Place the forward/off/reverse switch in the forward posi-
tion.
NOTE: Hold any handles, tubes, rollers, or pads over a
five gallon bucket. To clean these accessories, pull the
triggers aiming into the bucket.
 When as much paint as possible has been flushed through
the system and all attachments, turn OFF the machine.
 Disconnect all handles and attachments from the paint
tubes.
 Connect the cleaning accessory to the paint tube con-
nector.
 Set the forward/off/reverse switch in the forward posi-
tion.
 Hold the cleaning accessory firmly, flush the paint tubes
thoroughly over a five gallon bucket.
 Again, clean and rinse the container (not included).
 Fill the container with cleaning solution.
NOTE: Use this bucket to clean each part of the machine
as it is removed.
 Disconnect all paint tube(s) from the machine.
To clean the paint roller:
 Lift and remove the paint roller from the paint roller
assembly.
 Pull the roller caps off the paint roller and clean using
cleaning solution.
 Clean all parts in cleaning solution.
To clean the cut-in pads:
 Clean pads and all connections using a cleaning brush
(not included) and cleaning solution.
10 — English
Revolutionary White Formula Paint Thinner,
®
Green Safer Paint Thinner, or any other non-
®