Thermo Fisher Scientific TSV18CPSA Instalación Y Funcionamiento página 12

1. Use your Phillips head screwdriver to fix the bolts (1) into
the bolt holes (2) on the refrigerator door.
2. Put the handle on the door through the bolt (1), making
sure the handle contacts the surface of the door.
3. Use the handle screws (3) to fix the handle to the door.
Make sure the handle is attached firmly.
4. Put the cap (4) on the handle screw hole.
5. Follow the same procedure for installing the door handle
on the freezer door.
Figure 3. TSV18CPSA door handle installation
Reversing the Direction of the
Door Swing
This unit has the ability to open from either the right or the left
side. Reversing the door swing can be done yourself using the
following tools:
• Phillips head screwdriver
• Putty knife or flat head screwdriver
• 5/16" socket and ratchet
• Masking tape
Follow these steps to reverse the direction of the door swing:
1. Unplug the refrigerator, and remove all the contents.
Close the door and tape the door to the cabinet.
2. Remove the left cover plate and the top right hinge cover.
Unscrew the screws, and remove the top right hinge.
Save the screws, as you will need them to reattach the
door.
8 | Installation
3. Lift the freezer door up and away from the cabinet.
4. Unscrew the screws of the middle hinge, remove the
hinge, and then lift the refrigerator door up and away
from the cabinet. Save the screws, as you will need them
to reattach the door.
5. Unscrew the screws of the bottom hinge, then remove
the bottom hinge from the bottom right side of the
refrigerator.
6. Unscrew the hinge shaft from right side of the bottom
hinge, and move it to the left side.
7. Secure the bottom hinge to the left side of the
refrigerator, using the screws you previously removed.
8. Dismantle the sleeves from the top right of the doors and
the hole cap from the top left side of the doors. Assemble
them on the opposite side.
General Purpose Refrigerators and Freezers