Publicidad
Idiomas disponibles
Idiomas disponibles
▪ When using the electric tool, place yourself in a
stable position and always keep your balance. Hold
the electric tool to ensure continuous operation and
withstand unexpected situations, such as backlash;
The backlash is a sudden reaction that happens when
the tool is turned on and when the rotating accessory
gets stuck or is tightened. The counterstroke of the
rotating accessory causes the tool to be forced in the
opposite direction to the rotating accessory rotation.
Backlash occurs due to incorrect use of the electric tool
or work procedures not suitable for the work
performed. Loss of electric tool control can cause
serious injury. The following precautions must be taken
to avoid back-slipping:
- Place and hold the rotary accessory in the correct
position and tighten it securely;
- Do not position your body into the area to which the
tool will be used afterwards in case of backlash;
When the rotary accessory locks, immediately turn the
tool off.
▪ Make sure that the ventilation grids are not
obstructed during operation. Do not insert any
objects into the ventilation grids;
▪ The drilling accessories and hammer may become
too hot during operation. Avoid touching them, they
may burn. Wear protective gloves when changing
tools.
▪ Make sure you do not damage electrical circuits, gas
and water pipes when working with the tool. Any
damage to these elements may cause fire, explosion,
electric shock or material damage;
▪ Avoid using the tool on surfaces coated with paints
that contain lead or other materials harmful to
health. Contact with or inhalation of dust may cause
allergy reactions and/or respiratory diseases;
▪ Materials containing asbestos should not be
processed. Asbestos is carcinogenic.
26
Maintenance and cleaning
Remove the battery from the power tool before start
cleaning, adjustment, repair or maintenance work.
Replace worn out or damaged parts immediately so that
the power tool is always operational and in a safe
operating condition.
Cleaning:
Always keep the power tool clean and dry, free of oil,
grease and lubricants.
accessories of the power tool after use.
Do not use strong cleaning agents. These products can
damage plastics and metals and impair the safe
operation of your power tool.
Maintenance work:
Maintenance work may only be carried out as described
in these operating instructions; all other work must be
carried out by an official dealer.
Keep all nuts and screws well tighten so that the power
tool can operate safely.
If components or safety devices are removed for
maintenance work, they must be replaced correctly
immediately.
Use only attachable tools or accessories authorized by
VITO for this power tool or technically identical parts.
Otherwise injury or damage to the power tool may
occur. In case of doubt or if you lack the necessary
knowledge and means, you should contact an official
dealer.
Technical Assistance
Your electric tool should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts sourced directly from the manufacturer.
Clean all components and
Publicidad
