Publicidad
Idiomas disponibles
Idiomas disponibles
Operating mode selection
The electric tool can work in three different ways,
drilling, impact drilling and chiseling.
▪ The drilling mode ( ) is appropriate for metal, wood,
plastic and PVC, among others, position A;
▪ The impact drilling mode (
concrete, stone and masonry, position B;
▪ The chiseling mode (
concrete, wood, masonry and metal.
To align the chisel, turn the operating mode selector
switch (3) to position C. In this position the chisel is not
locked. This position only serves to adjust the chisel. To
work in chisel mode, you must turn to position D, where
the chisel remains locked.
To select the operating mode:
1. Press the locking tab of the operating mode selector
switch (3);
2. Turn the selector until you hear a "click". At this point,
the selector returns to the original position and locks
the selector at the selected position. Never work with
the selector set in the middle position;
28
) is used when drilling
) must be used when chiseling
3
Starting and stopping the electric tool
1. Press the "ON/OFF" switch (6) and touch the drilling
accessory to the surface you are about to drill;
2. Press the "ON/OFF" switch (3), to increase and
decrease the speed, press or release the "ON/OFF"
switch. The maximum speed is reached with the switch
fully pressed;
3. To turn the electric tool off, release the "ON/OFF"
switch;
During electric tool operation, the illumination LED
turns on (11).
Selection of the direction of rotation and locking of
the "ON/OFF" switch
Do not change the direction of rotation while the
electric tool is in operation, it can cause serious damage
to the electric tool. Always check the direction of
rotation before starting to use the electric tool.
1. Use the forward/reverse switch (5) to select the
direction of rotation of the shaft:
▪ With the forward/reverse switch on the left, the shaft
rotates clockwise;
▪ With the forward/reverse switch to the right, the
shaft rotates counter clockwise;
▪ When the forward/reverse switch is in the middle
position, the "ON/OFF" switch (6) is locked;
MAINTENANCE AND CLEANING INSTRUCTIONS
Remove the battery from the cordless lawn mower
before performing any checking, maintenance or
cleaning work.
The electric tool does not require any additional
lubrication or maintenance. However, regular cleaning
should be carried out in order to ensure continuous and
trouble-free operation.
Publicidad
