Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
Battery assembly
1. Insert the battery (8) into the cordless lawn mower
fitting and press the battery until you hear the "click
noise" of the battery lock/unlock button (9). At this
point the battery is completely secured;
2. To remove, press the Battery lock/unlock button and
pull out the battery;
Only use VITO 20V lithium batteries.
Battery charging
1. Place the battery in the charger as if you placed it in
the electric tool;
2. Plug the charger plug into the socket and let it charge.
Sometimes at the end of charging, both the battery and
the charger may be hot, which does not mean that they
are malfunctioning.
Allow the battery to cool down before putting it in the
machine.
Assembly/replacement of drilling accessories
Never install or replace the drilling accessories while the
electric tool is running. Always turn the electric tool off
before performing these operations.
1. Turn the Forward/reverse switch (5) to the middle
position to lock the "ON/OFF" switch (6);
2. Clean the drilling accessory and put grease into the
grooves;
3. Hold the electric tool and insert the drill accessory
into the dust shield hole (1);
4. Check that the accessory is securely fastened. Pull it
out and check that it is locked;
5. To remove the drill accessory, pull the locking sleeve
(2) back and remove the accessory;
Always make sure that the drill accessory is
assembled properly and securely before turning
on the hammer. Improperly assembled or loose
accessory can cause accidents and injuries.
Auxiliary handle assembly
The auxiliary handle (10) helps you to be more stable
when using the electric tool. Always use the auxiliary
handle.
The auxiliary handle is attached to the electric tool by a
clamp. Turning the handle counter clockwise opens the
clamp. Turning clockwise closes the clamp.
OPERATING INSTRUCTIONS
When working with the electric tool, you should
consider some precautions and operating procedures:
▪ Do not apply excessive pressure to the electric tool
against the workpiece/object. If the speed decreases
abruptly, reduce the pressure on the electric tool
immediately;
▪ When the drilling accessory locks, immediately
switch off the tool. Avoid the high reaction torques
that cause backlash;
▪ Never put the electric tool down until the rotary tool
has come to a complete stop;
▪ Turn off the electric tool immediately if any of the
following problems occur:
- Leakage of lubricant through ventilation holes;
- Damage to the electric tool housing;
- Damage to the "ON/OFF" switch;
- Appearance of smoke or characteristic burning smell;
27
Publicidad
