Greencut GS650X Manual De Instrucciones página 69

BOX CONTENTS
1
1. Chainsaw
2. Chain
3. Sword
4. Protector of the sword
5. Wash allen
6. Screwdriver for carburetor adjustment
7. File
8. Spark plug wrench
• Remove the product and accessories from the box. Make sure all items are present.
• Inspect the product to ensure that it has not been broken or damaged in transit.
• Do not discard the packaging material until you have carefully inspected and satisfactorily used the product.
ATTENTION: If any part is missing or damaged, contact the Official Technical Service. Do not use
this product without having replaced the missing or damaged part. Using this product with
damaged or missing parts can cause serious injury to the operator.
ASSEMBLY
ATTENTION: The chainsaw may come with plastic spacers on or around the sword bolts, the spacer
is for shipping purposes only and must be removed before mounting the sword. After removing the
brake cover, remove the plastic spacers you find and then mount the sword as described. Failure to
remove the spacers before mounting and using the chainsaw may result in injury, damage to the
unit and void the warranty.
Open the box and install the guide bar and saw into the power unit as follows:
1. Pull the chain brake handle toward the back of the saw (or pull toward the back of the saw if the chain
brake was installed on the saw).
2. Loosen the nuts and remove the unit from the chain brake cover assembly.
3. Install the claw (toothed part) on the unit (some models only).
4. Mount the chain on the sprocket and, while adjusting the chain around the guide bar, mount the bar in its
housing. The cutting chains are directional, so make sure you have them installed correctly.
4
2
5
10
3
13
9. Mixing pot
10. Hearing protector
11. Glasses
12. Gloves
13. M2 screws M5x10 (claw mount)
14. Gear lubrication pump (replacement)
15. Claw
7
9
6
8
11
15
14
69
EN
12