Installing The Robotic Mower; Preparing The Lawn And The Robotic Mower For; Operation - Stihl RMI 422 PC-LF Manual De Instrucciones

English
4. Lifting protection
If you attempt to lift the robotic mower by the hood or at the
carrying handles during operation, its lift sensor will be
activated and will stop the mowing blade within a short
period. Nevertheless, do not attempt to lift or reach under
the robotic mower for any reason without first activating the
disabling device and ensuring that the mowing blade has
stopped.
5. Tilt sensor
If the robotic mower exceeds the permissible incline of more
than 21.8° (40 %), the robotic mower will turn and continue
mowing in a different direction. An incline of 21.8°
corresponds to a vertical height increase of a = 15.7 in.
(40 cm) for a b = 39.4 in. (100 cm) horizontal distance.
Exclude such inclines from the mowing area and trim the
excluded area with a suitable line trimmer or other tool.
In the event of a rollover, the wheel drive stops and the
mowing blade will stop within a short period.
6. Illuminated display
The display is backlit during operation to help you track the
robotic mower in darkness.
7. Anti-theft alarm
When the anti-theft feature is activated:
– An alarm sounds when the robotic mower is lifted unless
the PIN code is entered within one minute, @ 15.4.
18
a
24°
b
– If you replace the docking station or robotic mower after
completing the initial setup, you will need to link the
robotic mower and docking station before use, @ 10.6.
8. GPS protection
For theft detection, STIHL recommends activating the GPS
protection feature. When GPS protection is activated:
– The registered owner of the robotic mower will be notified
through the iMow App if the unit is carried more than
1640 ft. (500 m) away from the perimeter of the
established mowing area, @ 15.4.
– When low, medium or high security levels are set, the
robotic mower can be operated outside the established
mowing area only after the security PIN code is entered,
@ 15.4.

10 Installing the Robotic Mower

10.1 Preparing the Lawn and the Robotic Mower for

Operation

To prepare the lawn for installation of the perimeter wire:
► Mow the lawn using a conventional lawn mower. An ideal
grass height is 2.4 in. (6 cm) or less.
► If the surface is hard and dry, water the mowing area
lightly in order to make it easier to drive in the perimeter
wire stakes.
► STIHL recommends that you install the perimeter wire at
least 11 in. (28 cm) from obstacles or the outer boundary
of your yard, @ 11. This will make continuous operation
of your robotic mower more likely. You may reduce
unmowed areas by installing the perimeter wire closer
than 11 in. (28 cm) to obstacles, but the successful
installation will depend on the particular characteristics of
your yard, @ 11.15.
10 Installing the Robotic Mower
0478-131-3050-A