Publicidad
Idiomas disponibles
Idiomas disponibles
Downloaded by: pd-oliana on 30-01-2023 15:52 CET
Do not use adhesives to stick the hob onto the worktop. Once the protective strip has been fixed to the
underside of the hob, place it into the hole made in the worktop. Carefully apply pressure to fit the hob into the
space, ensuring a good seal on the outer edge.
MAINS CONNECTION
This is a high power appliance and the electrical connection must be carried out by a qualified electrician.
This appliance must be connected to the domestic power circuit by qualified personnel.
Before connecting the hob to the electric supply, check that:
The home wiring can handle the power of the hob.
The voltage corresponds to the value stated on the label on the bottom of the appliance.
The cable cross section is capable of withstanding the load specified on the hob's label. Do not use adapters,
reducers or bypass devices to connect the appliance to the power supply, as these may lead to overheating and
fire.
The power cable must not be in contact with any hot part and be positioned in such a way that at no point does
its temperature exceed 75ºC.
Ask the electrician whether the home wiring system is adequate or needs to be modified. Any modifications
must be made by a qualified electrician.
Black/brown = L or phase
Blue = N or neutral
Green/yellow = E or earth
AFTER INSTALLING:
Check that the cable for the hob is not accessible through any doors or cabinets.
Check that there is adequate circulation of fresh air from the outside to the base of the worktop
If the hob is installed on top of a cabinet or drawer, install thermal protection under the base of the hob.
The isolation switch must be readily accessible to the user.
The hob can be fixed to the worktop by using the included metal brackets, as shown in the
images.
CAUTION: The metal brackets must not touch the inside surface of the worktop (see images).
I3021T:
Publicidad
