Taurus I3021T Instrucciones De Uso página 36

Downloaded by: pd-oliana on 30-01-2023 15:52 CET
To prevent any damage to the surface of the hob, use a suitable scraper to immediately remove
any remains of kitchen foil, food, splashed fat, sugar stains and other sugary foods. Then use a
towel and a suitable product to clean the surface, rinse with water and dry with a clean cloth. Do
not use abrasive sponges or cloths and avoid using harsh chemical detergents.
TROUBLESHOOTING
Problem
The induction hob will
not switch on.
The touch controls do
not work.
Heating stops suddenly
during use and the
display screen flashes
"u".
Touch controls are
difficult to operate.
Possible causes
No power
The accessory power board and
display board fail to connect.
The accessory power board is
damaged.
The controls are locked.
Wrong type of pot.
The pot diameter is too small.
The pot has overheated
There may be a thin film of water
on the controls. You may be using
the tip of your finger when
touching the control.
before switching the hob
back on again.
What to do
Make sure that the induction
hob is connected to the
power supply and that it is
switched on.
Check for a power outage in
your home or area. If after
checking everything the
problem persists, call a
technician.
Check the connection.
Replace the accessory
power board.
Disable the child lock as
explained in the instructions.
Use the correct pot (consult
the instruction manual).
The unit has overheated
Wait for temperature to
return to normal.
Make sure the touch control
area is dry and use the flat
of your finger when touching
the controls.