Genesis GMSUDR15L Manual Del Operario página 6

Keep the motor air slots clean and free of chips
•
motor.
Make sure all the saw's adjustment handles are tight
•
stops. Do not forget to tighten the rear mounted bevel adjustment handle.
never apply lubricants
•
never use saw blades
•
never start the tool
•
Allow the motor
• to attain full speed prior to starting the cut.
Always keep the blade guards
•
never reach around
•
never lock the switch
•
never attempt to recut small pieces.
•
never cut ferrous metals or masonry.
•
Do not perform free-hand cutting operations
•
when possible.
Long or wide work pieces should be properly supported.
•
iMPOrTAnT After completing the cut
• :
returning the saw to a raised position.
Turn off the saw and allow the blade
•
path of the blade. Coasting blades are dangerous.
Turn off the saw and allow the blade
•
piece angle, or changing the angle of the blade.
never perform layout,
•
Turn the machine "off" and disconnect the machine
•
before adjusting or changing set-ups, or when making repairs.
Disconnect the machine
•
if any part of your miter saw is missing, damaged,
•
shut off the switch and remove the plug from the power source. Replace missing, damaged, or failed parts before resuming operation.
WArning:
rEAD AnD UnDErSTAnD ALL WArningS, CAUTiOnS AnD OPErATing inSTrUCTiOnS BEFOrE USing THiS
EQUiPMEnT. Failure to follow all instructions listed below may result in electric shock, fire and/or serious
personal injury.
SAVE THESE INSTRUCTIONS
10" Slide Compound Laser Miter Saw
Operator's Manual
to the blade when it is running.
rated for operation at less than 5,000 rpm.
with the work piece against the blade.
in place and use at all times.
or behind the saw blade.
in the "on" position.
This miter saw is designed to cut wood and wood-like products.
, release the power switch and allow the blade to come to a complete stop before
to completely stop before cleaning the blade area or removing debris and off-cuts in the
to completely stop before removing or un-securing the work piece, changing the work
assembly or set-up work on the saw table or work area while the machine is running.
from the power source and clean the work area before leaving the machine.
, dust, or other obstructions which may impair the flow of cooling air to the
before cutting, even if the table is positioned in one of positive
. Hold the work firmly against the fence and table. Use clamps to hold the work
from the power source before installing or removing accessories,
or fails in any way, or any electrical component fails to perform properly,
GMSUDR15L