Descargar Imprimir esta página

GYS GYSFLASH 100-12 HF Manual Del Usuario página 14

Ocultar thumbs Ver también para GYSFLASH 100-12 HF:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 26
Shortcut to Lock Showroom :
The «Lock Showroom» feature can be activated without accessing the configuration menu.
• Turn the device OFF (switch on the OFF position)
• Press MODE key
• Turn the switch ON, while the MODE key is still pressed. The screen displays «GYSFLASH 100-
12 HF Vx.x» for 3 seconds.
• Hold the MODE key until the creen displays «lock showroom: Y»
• Cables calibration :
This mode must be used each time the cables are changed. The GYSFLASH can be fitted with cables up to
2x5m in 16mm².
OK : The calibration was successful.
FAIL : A problem occurred during the calibration. In this case, the calibration is reset to the factory setting.
Check that the cables are in good condition and properly put in short-circuit and repeat the procedure.
• ADVANCED MENU (code 1-9-6-4) :
This menu is intented for experimented user only.
To access this menu, enter in the code above («Select» key to change the code number and «Start/Stop» key to
confirm the code).
For more details, see page 15.
• Reset Memory (code 1-9-6-4) :
This menu is intented to factory reset the charger
settings by entering the code above. Any personal
parameters are deleted.
14
GYSFLASH 100-12 HF
RESET MEMORY
RESET MEMORY
RESET MEMORY
Code:
Code NOK
Error Code
Display 1s
RESET MEMORY
Code OK
RESET MEMORY
Reset all ?
EN
MODE
0
1
...
0000
9
Change the
code number
Code OK
(1964)
Yes
No

Publicidad

loading