Makita UH004G Manual De Instrucciones página 10

For UH006G/UH007G
Indicator
Reverse button for debris removal
WARNING:
If the entangled branches or
debris cannot be removed by the reverse function,
switch off the tool and remove the battery car-
tridge, and then remove the entangled branches
or debris using tools such as pliers. Failure to
switch off the tool and remove the battery cartridge
may result in serious personal injury from accidental
start-up. Removing the entangled branches or debris
by hand may cause an injury, since the shear blades
may move in reaction to removing them.
This tool has a reverse button to change the direction
of shear blades movement. It is only for removing
branches and debris entangled in the tool.
To reverse the shear blades movement, tap the reverse
button when the shear blades have stopped, then press
the switch lever and pull the switch trigger while press-
ing the lock-off lever. The speed indicators start blink-
ing, and the shear blades move in reverse direction.
To return to regular movement, release the trigger and
wait until the shear blades stop.
1
Fig.8
► 1 . Speed indicator 2. Reverse button
NOTE: If the entangled branches or debris cannot be
removed, release and pull the switch trigger until they
are removed.
NOTE: If you tap the reverse button while the shear
blades are still moving, the tool comes to stop and to
be ready for reverse movement.
Mode Stroke speed
High 4,000 /min
Medium 3,000 /min
Low 2,000 /min
Electronic function
The tool is equipped with the electronic functions for
easy operation.
• Constant speed control
The speed control function provides the constant
rotation speed regardless of load conditions.
• Electric brake
This tool is equipped with an electric brake. If the
tool consistently fails to quickly stop the shear
blades after releasing the switch trigger, have the
tool serviced at Makita Authorized Service Center.
• Accidental re-start preventive function
Even if you install the battery cartridge while pull-
ing the switch trigger, the tool does not start. To
start the tool, first release the switch trigger, and
then pull the switch trigger.
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
always wear gloves so that your hands do not
directly contact the blades.
NOTICE:
not wipe off grease from the gear and crank.
Installing or removing the shear
blades
CAUTION:
removing or installing the shear blades.
You can install 600 mm (23-5/8") or 750 mm (29-1/2")
shear blades to your tool.
1. Place the tool upside down, and then remove 6
bolts.
2
Fig.9
► 1 . Bolt
10 ENGLISH
Always be sure that the tool is
When replacing the shear blades,
When replacing the shear blades, do
Attach the blade cover before
1