Black and Decker LST220 Manual De Instrucciones página 10

CONVERT TO EDGING MODE
• To operate as a maintenance edger, turn
the collar (i) as shown in part 1 of
figure 10.
• Hold the metal shaft and rotate the lower
housing 180° as shown in part 2.
• Turn the collar (i) until tight.
• If desired, pull the wire edge guide (j)
out from the motor housing until it clicks
into the locked position as shown in
figure 11 and position the trimmer above
the surface as shown in figure 11.
• Return to the trimming position by
loosening the collar and rotating the lower
housing back 180°.
• Turn the collar until tight. When using the
tool, retract the wire edge guide to the
original position, out of the way.
CAUTION:
Wire edge
guide should only be used
when in the edging mode.
Keep wire edge guide in the
retracted position when in
the trimming mode.
10
i
11
10
j
CUTTING LINE / LINE FEEDING
Your trimmer uses .065 inch (1.65 mm) diameter, ROUND
nylon line. During use, the tips of the nylon lines will become
frayed and worn and the special self feeding spool will
automatically feed and trim a fresh length of line. DO NOT BUMP
unit on ground in attempt to feed line or for any other purposes.
Cutting line will wear faster and require more feeding if the
cutting or edging is done along sidewalks or other abrasive
surfaces or heavier weeds are being cut.
REPLACEMENT ACCESSORIES
CAUTION:
Before you begin trimming, only use the
appropriate type of cutting line.
Use Black & Decker replacement spool Model No. AF-100.
Reload nylon line (either bulk or prewound replacement spool) as
shown in this manual.
• USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON
MONOFILAMENT LINE. Do not use serrated or heavier gauge
line, as they will overload the motor and cause overheating. This
line is available at your local dealer or authorized service center.
• Other replacement parts (guards, spool caps, etc.) are available
through Black & Decker service centers. To find your local service
location call: 1-800-544-6986 or visit www.blackanddecker.com.
WARNING:
The use of any accessory not recommended by
Black & Decker for use with this tool could be hazardous.