Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
OPERATING INSTRUCTIONS
WARNING:
To reduce the risk of fire or explosion, do not operate this vac in areas with flammable gases,
vapors or explosive dust in the air. Flammable gases or vapors include but are not limited to:
lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol or aerosol sprays. Explosive
dusts include but are not limited to: coal, magnesium, aluminum, and grain or gun powder. Do not
vacuum explosive dust, flammable or combustible liquids or hot ashes. Do not use this vac as a
sprayer for any flammable or combustible liquid. To reduce the risk of health hazards from vapors
or dusts, do not vacuum toxic materials.
WARNING:
The operation of any utility vac can result in foreign objects being blown into the eyes, which can
result in severe eye damage. Always wear safety eyewear complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before starting operation.
CAUTION:
To reduce risk of hearing damage, wear ear protectors when using the vac for extended hours or
when using it in a noisy area.
This 3-gallon wet/dry vac is assembled at the factory and ready for use when you remove it from the
carton. The unit is ready for dry vacuuming or blowing. After you plug the power cord into the wall
receptacle, turn the unit "ON" by pushing the switch from position "O" to position "I". The "O" is
the "OFF" position and the "I" is the "ON" position.
O = OFF I = ON
ASSEMBLE THE HANDLE
Please install the handle as shown picture.
DRY PICK-UP
1. Slide cloth filter over lide cage (Picture1).
2. If you use your vacuum to pick up dust when the filter is wet,the filter will clog quickly and
be very difficult to clean.
3.
Attach power head to the tank and your vacuum is ready to use.
1
6
Publicidad
