JAROLIFT TDEP10/14 Instrucciones Originales página 22

GENERAL SAFETY INSTRUCTIONS
ATTENTION!
Observe the following fitting instructions!
Before fitting, compare the mains voltage/
frequency information on the type label with
that of the local electricity network.
When the operating direction is changed,
the changeover time must be at least
0.5 seconds!
The switches or controls used must not ex-
ecute an UP/DOWN command at the same
time!
Moving parts of motors that are operated
below a height of 2.5 m above the ground
must be protected.
The roller shaft must be mounted horizontal-
ly! If the roller shutter is rolled up at an angle,
the motor or the roller shutter can be dam-
aged.
The inspection cover of the roller shutter cas-
ing must be easily removable and accessible
and must not be wallpapered or plastered
over.
22
IMPORTANT!
According to DIN EN 13659, it must be en-
sured that the displacement conditions
specified for roller shutters in accordance
with EN 12045 are observed, i.e., roller shut-
ters are locked laterally.
For permanently installed devices, a cut-off
device must be present on the installation
side for each phase in accordance with DIN
VDE 0700.
Cut-off devices include switches with a con-
tact opening width of at least 3 mm (e.g.
circuit breakers, fuses, or RCDs) .
The manufacturer's liability for defects and
damage is excluded if these are due to
non-observance of the fitting and operating
instructions (incorrect installation, incorrect
operation, etc.).
IMPORTANT!
Disposal instructions!
(European Directive 2012/19/EU (WEEE))
Our electrical and elec-
tronic products are
marked with a crossed-
out wheeled bin indicat-
ing that these products
and any batteries they
may contain must be col-
lected separately at the
end of their life and must
not be disposed of with
your normal household
waste.