Publicidad
Idiomas disponibles
Idiomas disponibles
QUICK START GUIDE
1. Insert the included CR2450 button cell battery and close the cover.
2. Make sure the Bluetooth of your iOS device is on.
EN
3. Use the Home app, or download the free Onvis Home App and open it.
4. Tap the 'Add accessory' button, and scan the QR code on the CT3 to add the
accessory to your HomeKit network.
Note:
When QR code scanning is NOT applicable, select the target device (last
6 digits matching the MAC address), and manually input the SETUP code
printed on the cover page.
If the app prompts "Couldn't add Onvis-XXXXXX", please reset and re-add the
device. Please keep the QR code for future use.
The use of a HomeKit-enable accessory needs the follow permissions:
a. Settings>iCloud>iCloud Drive>Turn On
b. Settings>iCloud>Keychain>Turn On
c. Settings>Privacy>HomeKit>Onvis Home>Turn On
5. Name the CT3 smart contact sensor. Assign it to a room.
6. Set up a HomeKit hub (HomePod Mini and Apple TV4K2021) to enable
BLE+Thread connection, remote control and notification.
7. For troubleshooting visit:
HomeKit Hub Setting
Controlling this HomeKit-enabled accessory automatically and away from home
requires a HomePod, HomePod mini, or Apple TV set up as a home hub. It is
recommended that you update to the latest software and operating system.
To build an Apple Thread network, Apple HomePod mini or TV4K2021 is required.
You may find the instruction here:
http://www.onvistech.com/page-1717.html
http://www.onvistech.com/page-1718.html
Publicidad
