Publicidad
Idiomas disponibles
Idiomas disponibles
2. Thanks to the suction cup with sticky gel, the monitor can be installed
on the dashboard or on the windscreen of the car according to your
preferences. Fix the monitor inside your vehicle and adjust its angle,
ensuring that you can easily see its screen while it does not obstruct your
view of the surroundings. It is necessary to connect the RCA cable of the
rear camera to the RCA cable of the monitor.
3. Once the monitor and a rear camera are well installed and connected,
start your vehicle and put it into the reverse gear and then a forward gear
to test the camera and monitor. Make sure the camera automatically
becomes active when and only when your vehicle is in the reverse gear.
If needed, stop your vehicle and adjust the angle of the rear camera to
get a better view of the objects behind your vehicle.
Ensure you will be able to easily see small children and other obstacles
that would normally not be visible.
4. Use the 3.0A USB port to charge most of your electronic devices.
TECHNICAL DATA
Resolution
Rated voltage
Rated current
Monitor inputs
USB output
Operating temperature
This product meets all the basic EU regulatory requirements
relevant to it.
Selective collection of waste electrical and electronic
equipment. Electrical equipment must not be disposed of with
household waste. Pursuant to European Directive 2012/19/
EU on waste electrical and electronic equipment, and its
transposition into national law, waste electrical equipment
must be collected separately and disposed of in designated
collection points. Contact the local authorities or the vendor
for advice on recycling.
480 X 272 pixels
10-16V
20-200 mA
2 RCA inputs (V1 and V2)
5V, 3A
-20 °C ~ +70 °C
EN
19
Publicidad
