Hayward SP6050E Manual Del Usuario página 12

filtration system and cleaner operations. If the power to the time clocks is shut off or interrupted for any reason, the time
clocks must be reset. A longer than normal cleaning cycle is recommended for the first 30 days of operation. If an automatic
control system is used, please refer to the manufacturer's installation guide.
Starting the Pump:
The filtration system pump must be running, and an automatic pool cleaner must be connected before starting the booster
pump. If water leakage occurs from anywhere on the pump or filter, immediately turn off all system circulation pumps and all
electrical power before repairing the leak. Do not return to the pump or filter until all water flow has stopped. If no leakage
occurs, stand at least 10 feet from pump and/or filter and proceed with starting the pump.
•
WARNING – Return to filter to close filter manual air relief valve when a steady stream of water (not air or air and water
mix) is discharged from valve. Failure to do so could result in severe personal injury.
•
CAUTION – RISK OF EQUIPMENT DAMAGE. Never operate the booster pump without water. Water acts as a coolant
and lubricant for the mechanical shaft seal. NEVER run pump dry. Running pump dry may damage seals, causing leakage,
flooding, and voids warranty. The filtration system pump must be running before the booster pump is started. It is extremely
important for the booster pump to have an adequate water supply from the filtration system at all times. The booster pump is
not self-priming. To ensure that there is an adequate water supply for the booster pump:
• open any valves at the inlet and outlet of the booster pump before operation.
• set all filtration system valves in a manner that does not deprive the booster pump of water during operation.
• do not operate the booster pump without a pressure cleaner connected to the system.
• set time clocks such that the booster pump only operates when the filtration system is on.
• clean filtration system regularly to prevent flow restrictions.
•
CAUTION – RISK OF EQUIPMENT DAMAGE. Do NOT add chemicals to pool/spa system directly in front of pump
suction. Adding undiluted chemicals may damage pump and voids warranty.
If filtration system pump is to be turned off for any reason, then the booster pump must be turned off before turning off the
filtration system pump.
NOTE - If the Hayward booster pump is used to replace the booster pump in an existing pressure cleaner installation, then
the cleaner operating pressure should be reset according to the cleaner manufacturer's recommended procedure.
1. Hayward pumps have self-lubricating motor bearings and shaft seals. No lubrication is necessary
2. Keep motor clean. Insure air vents are free from obstruction.
3. Occasionally, shaft seals become damaged or worn and must be replaced.
4. Except for cleaning activities, any repairing, servicing and maintenance has to be performed by a Hayward authorized
service agent or a similarly qualified person.
1. Drain pump by removing drain plug(s).
2. Disconnect electrical wires and pipe connections, and store pump in a dry, well-ventilated room. Or, as a minimum
precaution: Disconnect electrical wires. Remove four bolts holding bracket and motor assembly to Strainer/Housing and
store assembly in a dry, well-ventilated room. Protect remaining Housing assembly from the elements by covering.
NOTE: Before Re-Activating pump, thoroughly clean and remove scale, dirt, etc.
Page 5 of 6
MAINTENANCE
WINTERIZING / STORAGE
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Booster Pump Rev. A