GB
MT
3. Work with the polish in a crosswise
movement or circular motions. Exert
only moderate pressure on the surface.
4. Please refer to the information from the
polish manufacturer.
Do not allow the polish to dry out.
There is a risk or surface damage.
Therefore, do not work in direct sun-
light or on a heated surface.
Dewaxing/polishing paint
surfaces
1. Use the synthetic polishing pad (4) to
remove wax.
2. Work in a crosswise movement or
circular motions. Exert only moderate
pressure on the surface.
3. Please refer to the information from the
polish manufacturer.
Cleaning and
maintenance
Switch off the device and re-
move the battery before car-
rying out any maintenance
work.
Have any work on the device
that is not described in this
instruction guide performed
by a professional. Only use
original parts.
Always check the device before using it for
obvious deficiencies such as loose, worn
or damaged parts, correct the position-
ing of screws or other parts. Examine the
polishing disc in particular. Exchange the
damaged parts.
26
Cleaning
Do not use any cleaning agent or
solvent. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
• Thoroughly clean the device after every
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.
• Hand wash to thoroughly clean the
covers after each use. Only use a mild
soap sud.
Storage
• Store the appliance in a dry place
(0 - 45 °C) well out of reach of children.
Waste disposal and en-
vironmental protection
Remove the battery from the device and re-
cycle the device, battery, accessories and
packaging in an environmentally-friendly
manner.
Electrical machines do not belong
with domestic waste. The crossed
out waste bin symbol means that
this device must not be disposed of with
household waste after its service life.
Do not throw batteries into domestic
waste, fire (risk of explosion) or wa-
ter. Damaged batteries can harm the
environment and your health if poisonous
fumes or liquids escape.
• Hand over the device at an utilization
location. The plastic and metal parts