Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting Group Play Mode
You can connect multiple audio systems in a wired group play mode to create a more interesting party
environment and to produce higher sound output.
Connecting the wired Group Play mode
1st
Sound Tower HOST
Connect the analog audio cable to the OUT(Group Play) of the HOST.
※ Sound Tower HOST can play music from any source.
Connect the analog audio cable to the IN(AUX2) of 2nd Sound Tower and Set the source to AUX2.
Set up Group Play by connecting all the systems using analog audio cables.
Use the AUX or
the Sound Tower HOST.
• Set one Sound Tower as the HOST and any music played on it will be shared among any other
Sound Tower in the Audio group.
NOTES
• Analog audio cables are not supplied.
• Depending on the length or characteristics of the cable, there may be a difference in operating
distance.
• Be sure to select the Audio In function on the last system.
• In this configuration, the sound from the last system may lag behind others.
• To stop Wired Group Play:
– Remove analog audio cable from the HOST
– Change to a source other than AUX2 on any Sound Tower in the group besides the HOST
– Turn off the HOST
• If the Wired Group Play function does not start:
– Check the connections.
– Ensure the audio cables are connected correctly.
2nd
Sound Tower
(Source) button to change the source to AUX2 for every Sound Tower except
RCA cable
(not supplied)
AUX2 white LED on
AUX2 white LED on
Continue these steps
to connect Sound
Towers until the last
one is connected.
ENG - 9
Last
Sound Tower
Publicidad
