Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
ASSEMBLY
Carefully read these instructions and this manual in its entirety, before you attempt to operate your
new shredders.
Your new shredder/chipper has been pre-assembled at the factory, with the exception of those
parts left unassembled for shipping purposes. All parts such as nuts, washers, bolts, etc. necessary
to complete the assembly have been attached on the machine. To assure safe and proper
operation of your shredder/chipper, all parts and hardware you assemble must be tightened
securely. Use the correct tools needed to assure proper tightening.
I UNPACKING INSTRUCTIONS
WARNING:To prevent personal injury or property damage, do not attempt to
start the motor until all assembly steps are complete and you have read and
understand the safety controls and operating instructions in this manual.
INTRODUCTION
Please carefully follow these assembly steps to properly prepare your machine for use. We
recommend that you read this Section in it's entirely before beginning assembly.
NOTE: All references to left, right, front and rear of the machine are determined
by standing behind the handlebars and facing the direction of forward travel.
INSPECTION AFTER DELIVERY
When unpacking the machine, inspect for shipping damage or missing parts, if you find any
damage, or if parts are missing, notify the BENZA Dealer who sold you the machine.
TOOLS/MATERIALS NEEDED:
Active Wrench
UNPACKING STEPS
Cut plastic banding. To open the box, remove top plywood panel firstly,
Remove the filling hopper and the feed intake opening tube.
Remove all around wall panel.
Remove machine from the wood pallet.
Check the box thoroughly and remove additional loose parts included with the shredder/chipper.
Remove all packing materials.
II HOW TO SET UP YOUR CHIPPER/SHREDDERS
CAUTION:Wear protective gloves during operation of setting up your
shredders/chippers.
14
Publicidad
