Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
1. PRE-OPERATION CHECKLIST
Before using the electric chipper/shredder, with the power cable disconnected from the machine,
please perform the following procedures for the personal and property safety of the operator and
jobsite and for optimal performance.
1) Review section"safety"and section"features and Controls"which is in this owner's manual. Read
all safety, controls and operating instructions on decals located on machine.
2) Check and make sure that all nuts and bolts, especially the blade attachment-bolt, are tighten
and all guards and deflectors are in place and in good working condition. Tighten or replace as
needed. If there are any worn or damaged parts, DO NOT ATTEMPT TO OPERATE THE
MACHINE. Make note of required parts, and contact BENZA'S local dealer or BENZA's exclusive
national distributor for replacement parts and further assistance to service the unit PRIOR to any
further use.
3) Check and make sure that all motor controls and the brake action functioning within acceptable
tolerances.
4) Tighten any screws where necessary! Check the screws again after around 20 working hours!
5) Pay attention that the filling hopper is properly mounted!
6) Check and make sure that the cutting chamber is empty.
CAUTION: If any of the above checks fail, please take necessary steps to maintain
or repair the unit before operating it in any environment.
CAUTION: Always wear proper safety clothing and equipment for the job.
These can and should include eye and ear protection, gloves, dust mask and any
other items that are appropriate for the job and jobsite requirements.
WARNING: Before operating the machine, be sure to read all safety, controls and
operating instructions in this Owner's Manual and on decals located on
machine.Server personal injury or property damage could result if this instruction
is not followed.
2. OPERATING THE SHREDDER
Attaching the connecting cable
Note:A connecting cable with a minimum quality of H05RN-F according to DIN 57
282/VDE 0282 and a rubber-coated connector (minimum cross 2 sector 1.5 mm ) is
required to operate the shredder. The benza safety cable fulfills these
requirements. The device must be connected to a 230 V a.c, shock-proof socket
with 16 A fuse protection.
The connecting cable should be at least 15 meters long-through a maximum of 40 meters. Longer
connecting cables reduced the electric motor's output.
First connect the connecting cable to the socket on the switch casing and secure with the safety
hook.
Then connect the other end to the mains.
When disconnecting the cables always remove the plug from the mains first.
17
ENGLISH
Publicidad
