Publicidad
Idiomas disponibles
Idiomas disponibles
Changing the blades
• Switch off motor and disconnect mains plug,
wear protective gloves!
• Unlock the lock handle and remove the feed
intake tube with filling hopper.
• To remove the shredder disk by loosen the
hexagon central bolt with counter-screw.
• Then take out the shredder disc from the adapter
of brake disc. loosen all screws on shredding disc
to remove blades, then grind or replace the
blade.
• Replace and fasten the new blade with new
screws and nuts.
• Replace the shredding disc back into place.
• Replace the lock disc and screw the shredding
disc to motor spindle tightly with central bolt.
NOTE: Replacement blades are
shredding blades(part No. 4SH0402010)
and chipping blades(part No.
4SH0403010).The blades normally have
to be replaced after around 20 working
hours. Blunt or worn blades reduce the
shredding performance!
Servicing the wheels
Grease the bearings of the wheels once a year. Loosen the hexagon head cap screws until the
wheels can still be easily rotated.
2. Troubleshooting
Motor does not start or shredder stops during shredding:
• No mains power = check the fuse protection
• Connecting cable or plug or connector coupling faulty = have these checked by an expert.
• Motor switched off by overload protection = blockage in cutting gear.
• Shredder blades blocked by material = open feed intake opening, remove material to be chopped,
• Blockage in the cutting chamber = switch motor off, remove mains plug. Open the feed intake tube.
• Rotate shredding disk on counter-clockwise and remove chopped material.
• Faults/blockages in the cutting chamber can be caused by blunt blades.= have the machine checked
by the specialist.
Please contact your local BENZA dealer for any disorders and faults that are not shown here. Any repairs
requiring specialist knowledge should be performed by a specialist. Your local BENZA dealer will also be
happy to help you. You should not wish to carry out the maintenance work described above yourself.
21
ENGLISH
Publicidad
