Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Safety switch
This is a stop switch located near the opening
of shredding chamber, which interrupts the
power supply to the motor when the shredding
chamber is opened by turn the feed intake
tube. The machine can not restart until the
feed intake tube insert into the opening again.
Operation switch
The operation switch under the shredding
chamber has the following functions:
Press switch=On/Off switch
Mushroom switch=Emergency stop switch;
interrupts the power supply to the motor
Overload protection=Switches the motor off
when the motor/shredder disc is blocked for
longer than 5 sec.
Switching the motor on
Open the yellow cover and press the green button marked" ", the motor and shredder disc start.
Note: If the shredder is overload, the protection will act and turn off the motor at once for protecting
the motor.
Then the machine can not restart directly by press the green button. You need to press a reset
button on the left side wall of the switch firstly, and then can you restart the machine through the
green start button.
Note: If the shredder works continually for some time, the thermal protection may act and turn off
the motor. You have to wait a few minutes to let the motor to cool down. Then you can restart the
machine again.
Attention!
As soon as the motor starts the shredder disc starts to rotate, always switch the motor off if the
shredder is to be left alone for any length of time. Disconnect the mains plug too if any work is to be
carried out on the machine.
Switch off the motor
Open the yellow cover and press the red button marked "O", or press red mushroom button directly
in an emergency:
Push the red mushroom button (Emergency Stop); e.g. if the shredder disc is blocked!
Transporting the shredder
Tilt the filling hopper backwards holding the handle with one foot placed firmly on the wheel axle.
The shredder can be wheeled around in this position.
Note:For your own safety the safety instructions at the beginning of these
operating instructions are to be read and observed when using the shredder.
18
Publicidad
