Descargar Imprimir esta página

Schulz PRO CSL 10/100 Manual Del Usuario página 51

Publicidad

Idiomas disponibles

Idiomas disponibles

6. INSTALLATION
1. Initial Set-up:
• Remove the product from the package with the assistance of a pulley, forklift or an appropriate lifting device
(if applicable)
• Verify if the product does not present problems due to transport and whether it is in operating conditions.
When included in the product:
• Assemble the wheels, mount, handle and rubber foot (Figures 6.1 to 6.6).
• Remove the plastic plug lodged in the air fi lter, in the cylinder cover and in the brace. Next install the air
fi lter (fi gure 6.7).
ATENCIÓN
• For MSV 6, CSD 5 and CSA 6.5 models, it is essential to install a vacuum pump. For other information see
attached technical data sheet.
ATENCIÓN
The spigot connected to the block has a starting system pressure relief hole. Do not obstruct it. (Figure 6.8)
Gasoline Engine:
• Install the compressor in a clean, dry and well-ventilated area.
• Read the Instruction Manual of the engine that comes with this air compressor, for the correct starting pro-
cedure of the engine and correct maintenance and safety procedures.
• Read and understand the safety stickers located on the compressor's tank.
• We recommend the use of fuel with octane of at least 85, for the engine of this compressor.
• Do not mix oil with gasoline.
• We recommend the use of clean, new and unleaded gasoline. Do not use gasoline that contains methanol
or a high percentage of alcohol.
• Check the level of lubricant oil, before starting. (Check the Instruction Manual of the engine)
• Fill the fuel tank according to the instructions of the engine's Manual.
• Always consult the engine's Instruction Manual, for all the necessary adjustments and maintenance proce-
dures.
FIGURA 6.1
Oil-free compressors:
CSD 5 compresor:
FIGURA 6.2
49
FIGURA 6.3

Publicidad

loading

Este manual también es adecuado para:

Pro csv 10 adPro csv 10/50Pro csv 10/100Pro csv 10/200