Publicidad
Idiomas disponibles
Idiomas disponibles
3.2
Using a mains
adaptor
Note that you have to reset the date and time each time you replace the
batteries, unless this is set automatically via the radio clock when the device
is switched on using the ON/OFF switch
are saved.
WARNING
BATTERY SAFETY INFORMATION
• Do not disassemble batteries!
• Clean the battery and device contacts if necessary before
putting in the batteries!
• Remove discharged batteries from the device immediately!
• Increased risk of leakage, avoid contact with skin, eyes and
mucous membranes! If battery acid comes in contact with
any of this parts, rinse the affected area with copious
amounts of fresh water and seek medical attention
immediately!
• If a battery has been swallowed seek medical attention
immediately!
• Replace all of the batteries simultaneously!
• Only replace with batteries of the same type, never use
different types of batteries together or used batteries with
new ones!
• Insert the batteries correctly, observing the polarity!
• Keep the battery compartment well sealed!
• Remove the batteries from the device if it is not going to
be used for an extended period!
• Keep batteries out of children's reach!
• Do not attempt to recharge these batteries! There is a
danger of explosion!
• Do not short circuit! There is a danger of explosion!
• Do not throw into a fire! There is a danger of explosion!
• Keep unused batteries in their packaging away from metal objects
in order to prevent short circuiting!
• Do not throw used batteries into the household refuse;
put them in a hazardous waste container or take them to
a battery collection point, at the shop where they were
purchased!
Alternatively, you can also run the device using a special power supply unit
(MEDISANA item no. 51036 not supplied). Connect it to
the device. In this case the batteries remain in the unit.
Inserting the connector into the back of the blood pressure monitor switches
the batteries off mechanically. It is necessary, therefore, to plug the mains
adaptor into the mains socket first of all and then to connect it to the blood
3 Getting Started
. The previous measuring results
on the back of
GB
23
Publicidad
