Cramer 82CS25 Manual De Instrucciones página 11

and do not operate this product until all missing or damaged parts are replaced.
Please call Customer Service for assistance.
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING!
Do not at any time let brake liquids, gasoline, petroleumbased
products, penetrating oils, etc.,come in contact with plastic parts.
Chemicals can damage, weaken or destroy plastic which may
result in serious personal injury.
Only the parts shown on the parts list are intended to be repaired or replaced by
the customer. All other parts should be replaced at an authorised service centre.
STORAGE
Storing the product
•
Remove the battery pack from the unit before storing.
• Clean all foreign material from the unit.
• Store it in a place that is inaccessible to children.
•
Keep away from corrosive agents such as garden chemicals and de-icing
salts.
• Store and charge your batteries in a cool area. Temperatures above or below
normal room temperature will shorten battery pack life.
•
Never store batteries in a discharged condition. Store battery packs in a
30%- 50% charged condition.
• Store the battery pack where the temperature is between 0-23* C and
away from moisture.
•
All batteries gradually lose their charge. The higher the temperature, the
quicker they lose their charge. If you store your unit for long periods of time
without using it, charge the pack as normal every six months of storage.
This practice will prolong battery pack life.
Troubleshooting
PROBLEM PROBABLE CAUSE
Check saw chain tension for
overtightened condition.
No oil in the oil tank.
The discharge port is
Bar and
blocked by debris.
saw chain
running
Oil tank is blocked by
hot and
debris.
smoking.
Bar and chain oil tank cap is
blocked by debris.
The sprocket or guide wheels
is clogged with debris.
Saw chain tension is too
tight.
Check guide bar and saw
chain assembly.
Motor
runs, but
chain is not
rotating.
Check guide bar and saw
chain for damage.
EN
POSSIBLE SOLUTION *
Tension saw chain.
Refill oil into the oil tank.
Refer to the manual to remove
the bar and clean out the debris.
Clean out the oil tank and refill
with clean oil.
Clean the debris off the oil cover.
Clean and remove debris from
sprocket and guide wheel.
Refer to Saw Chain Tension
Guide earlier in this manual.
Refer to Replacing the Bar and
Saw Chain assembly earlier in
this manual.
Remove the battery from the
unit. Take the bar cover off,
and remove the bar and saw
chain. Clean all debris from the
chain saw. After all debris is
cleared, insert battery and run
the chain saw. If the sprocket is
spinning your motor is okay. If
the sprocket is not spinning, call
customer service.
11
cramer.eu