Cramer 82CS25 Manual De Instrucciones página 12

EN
Dull chain.
Motor
runs, chain
rotates but Chain on backwards.
does not
cut.
Chain tension could be
overtightened or too loose.
The chain brake is engaged.
No electrical contact
between the chain saw and
battery.
The battery pack is
depleted.
Chain saw
does not
The lock-off lever and
start.
trigger are not depressed
simultaneously.
The battery and power tool
is too hot or too cold.
The machine cannot work.
when the red light flash
and it checks itself for the
protection.
12
cramer.eu
Sharpen or replace the saw
chain.
Refer to Replacing the Bar and
Saw Chain assembly earlier in
this manual.
Refer to Re-tensioning the saw
chain in the manual.
Pull the chain brake towards
you until the chain brake is
disengaged.
To secure the battery, make
sure the latches on the battery
compartment snap into place.
Charge the battery pack.
Press down the lock-off lever and
hold it, then depress the trigger
to turn on the chain saw.
Refer to the battery and charger
maintaince part in the manual.
Press down the trigger first
then start the power button
the machine cant work before
solving its faults.
Start the machine, red light
flash and the machine can
not work.
Motor stops after about 3
seconds.
If the unit cuts off and
beeps during a cut, it went
into protection mode. This
protects the PCB from
damage.
Motor
running,
Battery is not charged.
but cutting
abnormal.
The saw chain needs
lubrication, and will increase
friction if not properly
maintained.
Incorrect battery storage
temperature.
* If the fault is not solved, you must go to your distributor and/or nearest Authorized
Technical Service.
The machine checks itself for the
protection. You can :
1. Install the battery, press the
trigger, and then press the power
button.
2. The machine will keep flashing
light and sound hums.
3. Remove the battery
4.Re-start the machine.
Recharge the battery.
Release the trigger and restart
the chain saw. Let the chain saw
do the work and do not force
the cut.
Charge the battery. Refer to the
battery and charger manual for
correct charging procedures.
Make sure the chain is always
lubricated by never letting the bar
and chain oil run low.
Allow the battery pack to
cool until it drops to room
temperature.