VebaBox TUF1005 Manual Del Usuario página 15

operation of VebaBox. During defrost cycle (max. 20 minutes) the
freezing is inactive.
In case you notice power of freezing unit is decreasing rapidly or ice
on evaporator, you can activate the defrost function manually by
pressing the defrost button for 2 seconds. After defrost procedure is
finished, the unit automatically returns to normal operation.
Remote control
Thermal unit installation can contain remote dashboard control. If
installed, some specific conditions apply:
•
Remote display has priority in control of temperature. If
connected, the display on the thermal unit cannot be used for
setting of temperature and is not taking part in temperature
regulation.
•
The same rules as described in section "controls" apply for
the remote display (including setting of temperature in box)
•
Do not use power switch on thermal unit. This switch should
be in position "0" all the time. Use switch on remote control to
operate the unit.
6. Cleaning and maintenance
WARNING: Never allow water or other liquids to enter the thermal unit
and electronics.
•
Turn off the product and disconnect all power cables.
•
The VebaBox is not designed for automatic defrosting (not
necessary for normal operation). If excessive frost builds up,
shut off the unit and wait until the ice melts. Do not remove
the ice by mechanical means.
•
Clean the product with a damp cloth, using a detergent if
necessary. NOTE: do not use abrasive or corrosive agents as
these may damage the surface.
•
Carefully dry all remaining damp parts with a dry cloth.
TUF1005 and TUF1010-usm. rev.00
© 2020 VebaBox B.V. User Manual VebaBox+ TUF1005+TUF1010
15