Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Front Handlebar / Fork Assembly:
1.
Place the handlebar
2.
Insert two screws
stem tube mount
3.
Place a washer and nut (
4.
Secure the handlebar onto the stem tube with the nuts provided.
5.
Tighten the nuts enough that they will not come loose (recommended torque is 7.3 ft
lbs - 10 N•m).
6.
Place Fender
o
7.
Place a spacer
u
8.
Insert the steerer tube of the fork through the headtube and headtube bushings from
bottom to top.
9.
Orient the slot
10. Place the clamp assembly
line with the slot in the steerer tube.
11. Slide basket (if equipped) and then the clamp cover
sible.
12. Insert the stem tube
Note: Ensure that the minimum insertion mark on the stem tube is not visible - below the
top of the steerer tube.
13. Align the handlebar so that they are perpendicular with the front wheel.
14. Secure the handlebar in the steerer tube by tightening the clamp bolt
ed torque is 19.2 ft lbs - 26 N•m).
15. Check that the clamp is tight enough so that the handlebar will not rotate inside of the
steerer tube.
16. Slide the clamp cover over the clamp.
17. Secure the basket (if equipped) using the bracket and hardware provided.
18. Install the accessories (plaque, bell, pad, streamers – if equipped) onto the handlebar.
Rear Axle / Wheel Assembly:
1.
Place one wheel
2.
Ensure wheel bushing
3.
Slide the axle/wheel through the rear of the scooter.
Note: On some models the rear bushings are pre-assembled into the scooter at the
factory. On other models the rear bushings must be installed into the rear of the
frame.
4.
Place the other wheel
5.
Place the washer
6.
Tighten the axle nut to secure the axle assembly (recommended torque is 7.3 ft lbs - 10
N•m).
7.
Snap a hubcap
Assembly Instructions
onto the stem tube
q
through the holes in the handlebar and the mating holes in the
e
.
r
-
) onto each screw.
t
y
(if equipped) over Fork
onto Fork
steer tube.
i
A
in the top steerer tube toward the rear of the unit.
onto the steerer tube with the open end of the clamp in-
a
FULLY into the Fork steer tube.
w
onto the axle
d
f
B
points inwards.
onto the axle.
d
and the axle nut
g
(if equipped) onto each rear wheel.
j
.
w
steer tube.
i
s
.
onto the axle.
h
as far up the stem tube as pos-
(recommend-
a
7
Publicidad
Tabla de contenido
