Publicidad
Idiomas disponibles
Idiomas disponibles
Daily Use
Daily Use
Defrosting
The evaporator, however, will become progressively covered with frost. This should be removed.
Never use sharp metal tools to scrape off frost from the evaporator as you could damage it.
However, when the ice becomes very thick on the evaporator, complete defrosting should be carried out as
fellows:
pull out the plug from the socket;
remove all stored food, wrap it in several layers of newspaper and put it in a cool place;
keep the door open, and placing a basin underneath of the appliance to collect the defrost water;
when defrosting is completed, dry the interior thoroughly
replace the plug in the power socket to run the appliance again.
Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician of
competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not
work
The food is too warm.
Appliance cools too
much
Unusual noises
If the malfunction shows again, contact the Service Center.
Possible cause
Temperature regulation knob is
set at number "0".
Mains plug is not plugged in
or is loose
Fuse has blown or is defective
Socket is defective
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Temperature is set too cold.
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
19
Solution
Set the knob at other number to
switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Please look in the initial Temperature
Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to
a colder setting temporarily.
Please look in the installation
location section.
Turn the temperature regulation knob
to a warmer setting temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
Publicidad
