Publicidad
Idiomas disponibles
Idiomas disponibles
RULES FOR CONVERTING AND INSTALLING FOR OTHER TYPES OF GAS
Our appliances are tested and regulated for liquid gas (see plate inside).
The conversion or adaptation to another type of gas must be carried out by a specialized technician. The nozzles for the
various types of gas are in a bag supplied with the appliance and marked in hundredths of mm (see the "Technical Data"
table).
SUBSTITUTING THE NOZZLE IN THE MAIN BURNER
•
In order to operate inside the appliance, it is necessary to empty the water tub.
•
Remove the small knob from the panel by unscrewing it.
•
Remove the front fixing screws from the panel, remove the start up cable from the piezoelectric ignition device.
•
Using a suitable spanner, unscrew the nozzle and substitute it with the right one (see the "Technical Data" table).
•
The main burner does not require any regulation of the primary air.
SUBSTITUTING THE NOZZLE IN THE PILOT BURNER
The flame of the pilot burner has fixed air.
The only operation necessary is the substitution of the nozzle according to the type of gas.
It is therefore necessary to unscrew the screws as specified in the previous point; with a suitable spanner unscrew the
fitting and substitute the nozzle with a suitable one. With the right nozzle, the flame must lap the thermocouple.
Important!
After having carried out the conversion to another type of gas, it is necessary to update the data plate, indicating the
type of gas for which the appliance has been converted.
•
The instructions necessary for use are enclosed with the appliance.
•
Check the appliances for gas leaks.
•
Examine the flame of the pilot burner; it must lap the thermocouple and be blue, otherwise examine the nozzle of
the pilot burner.
•
Check the lighting and flame of the main burner.
•
We urge the user to follow the instructions when using the appliance.
With prolonged use of the appliance, it is essential to carry out regular maintenance for the safe functioning of the
appliance; we therefore recommend drawing up a contract for after sales service.
Maintenance must only be done by specialized personnel, observing the norms in force and our indications.
It is possible to substitute parts such as the valve, the piezoelectric lighter or gas pipes very simply. To substitute the
parts, proceed as follows:
•
Valve: after removing the front panel, unscrew the screwed fittings of the gas connections, remove the fitting and
take out the thermostat bulb, then substitute the faulty parts, installing the new ones in sequence.
•
To substitute the thermocouple, unscrew the pilot burner fitting, likewise the valve fitting and substitute the
element.
•
The spark plug must be unscrewed and substituted.
Attention!
Before lighting the appliance, it must be washed with water and washing-up liquid, rinsed thoroughly and filled with
water up to the level indicated by the mark on the back of the water tub.
DO NOT START UP THE APPLIANCE WITH THE WATER TUB EMPTY.
It is advisable to connect the appliance to the hot water pipe (max.60°C) to reduce heating time; it is also recommended
to install a cut-off cock upstream from the appliance.
The drain piping must be connected to a suitable drain and be compliant with the norms.
GB
CHECKING FUNCTIONING
MAINTENANCE
SPARE PARTS
WATER CONNECTION AND DRAINAGE
IE
29
Publicidad
