Publicidad
Idiomas disponibles
Idiomas disponibles
The piping must be connected in such a way as to avoid contractions or siphons. Drainage of the water is free, therefore
it is essential that the drain is lower than the outlet of the piping.
The appliance must be connected to an equipotential system. The connection screw is positioned at the back of the
appliance and is identified by the
Attention! The manufacturer will neither be held responsible for, nor will give any compensation during the guarantee
period for any damage caused, and which is due to inadequate installations not compliant with the instructions.
Starting up
Before using the appliance, it is necessary to clean it carefully, especially the water tub (see paragraph "cleaning and
care").
Check the connection of the appliance and start it up following the instructions, "Instructions for use".
Attention!
- Use the appliance only under surveillance.
Water filling
Check that the drainage tap is in the "off" position.
Fill the tub with water up to the level indicated by the mark, by pressing the button.
Lighting the pilot burner
Check that the thermostat knob is in
Keeping the knob pushed down, press the piezo button repeatedly. The flame lights automatically and can be seen
through the inspection hole in the front panel. After lighting, hold the knob down for another 20-30 seconds, to allow
the thermocouple to warm up, then release it. The flame may go out, in which case it is necessary to repeat the
procedure.
Lighting the main burner and regulating the temperature
After releasing the knob, the gas flows into the safety valve.
Turning the graduated knob from 30 a to 90° C, the gas flows to the main burner which then lights.
Putting out the main burner
Turn the knob into
position; only the flame of the pilot burner remains lit.
Turning off the appliance
Push and turn the knob into position "0". This command blocks the gas supply to both the main burner and the pilot
burner.
Emptying the tub
Turn the drainage tap from the "off" position to "on".
NB: pay attention to the distance between the appliance and the corners of the support.
it is recommended to carry out this operation using water which is not too hot.
NB:
GB
IE
EQUIPOTENTIAL
symbol.
position.
30
Publicidad
