Mighty Seven DJS-101 Manual De Instrucciones página 12

LED WORKLIGHT (FIG. 3)
FIG. 3
LED
Worklight
The LED worklight, located above the tool-
less blade clamp, provides additional lighting
on the surface of the workpiece for operation
in lower-light areas. The LED worklight will
come on automatically when the trigger
switch is depressed, and it will turn off when
the trigger switch is released.
INSTALLING SAW BLADE (FIG. 4)
FIG. 4
1. Remove the battery pack.
2. Turn the tool upside down and press the
blade clamp lever as far as it can go; the
lever will not rebound back.
3. Insert the blade into the slot until it locks
into place automatically
12
ASSEMBLY
REMOVING SAW BLADE (FIG. 4)
CAUTION:
!
Allow the blade to cool after use. The blade
can become dangerously hot.
1. Remove the battery pack.
2. Press down on the blade clamp lever to
remove the blade.
3. The clamp stays open when the blade is
removed; it automatically locks when you
push in another blade, providing for very
easy one-hand blade change.
To obtain the best performance from the saw,
it is important to select the correct blade for
the particular application and type of material
you wish to cut. By doing this, you will get a
smoother, faster cut and prolong blade life.
The jigsaw has orbital action whereby the
blade roller guide moves back and forth to
make the blade swing slightly as it cuts.
Orbital action increases the speed of cut but
may result in a rougher finish to the cut in
some materials.
BLADE SELECTION
FIG. 5