Publicidad
Idiomas disponibles
Idiomas disponibles
Set the orbit control lever to one of the four
settings according to degree of orbit action
required:
0 No orbit action
1 Minimal orbit action
2 Medium orbit action
3 Maximum orbit action for the most
aggressive action, for quick cutting plywood
or soft material.
Experiment on a piece of scrap material to
determine the optimum orbit action setting.
ADJUSTING THE SHOE
FOR ANGULAR CUTTING
(FIG. 6&FIG. 7)
FIG. 6
FIG. 7
OPERATION
!
Always ensure that the jigsaw is switched
off and the battery pack is removed before
making any adjustments.
1. Loosen the hex screw located on the
underside of the tool using hex key.
2. Move the shoe plate backwards so that the
teeth on the plate no longer engage with
the retaining teeth and the shoe can be
tilted to the left or right.
3. Select 15°, 30° or 45° to the left or right or
select 0°, and push the shoe plate forward
so that the teeth on the plate mesh with the
retaining teeth.
4. Retighten the hex screw.
The angle selected can be read on the cutting
angle guide on the shoe plate.
For accurate work it is necessary to make
a trial cut, then measure the work and reset
the angle with the shoe plate moved a little
towards the rear so that the teeth on the plate
do not mesh with the retaining teeth.
Repeat the trial cut and reset the angle
setting until the correct setting is achieved.
The parallel guide fits into the shoe plate and
is locked in place by the locking screw.
Use the parallel guide to guide the jigsaw
along a straight line which can be an edge
of a workpiece or a piece of straight timber
clamped to the workpiece.
CAUTION:
PARALLEL GUIDE (FIG. 8)
FIG. 8
13
Publicidad
