Rain Bird TBOS Manual De Instrucciones página 11

english
• If the On-off Mode is deactivated, you will see the
icon, indicating that the Control
Module will water according to current program-
ming.
• If the On-off Mode is activated, you will see the
icon, indicating that all Control
Module programs have been overridden and no
watering will take place.
Performing Manual Starts
and Stops
Important: Before you perform manual
starts and stops, you must verify the
Control Module's irrigation status. See
Verifying the On-off Mode, above.
Note: The manual functions described
below override all other functions
(except On-off); any program currently
running will be suspended to permit
their use. Manual starts and stops only
affect an existing station run time or
program.
Important: Manual operations will not
work if the On-off Mode is activated.
Starting a Control Module
Manually
You can perform either a single-station or a cycle
(multi-station) manual start. Before carrying out
either type of manual start, make sure you have pro-
grammed a run time of at least one minute per sta-
tion and that the Control Module's On-off Mode is
not activated.
18
TBOS ™
Field Transmitter
Performing a manual single-station start
If you would like to manually
start one station:
N
B
1. Press until the
icon is displayed.
The station num-
ber will also be
displayed.
P
2. Press to stop any stations that may be
watering. If a station is in operation, a manual
start is impossible. A station may be in operation
at the module level, but without any irrigation in
the field. This is what occurs when the Rain Shut-
off Device prevents programmed irrigation.
C
3. Press until the station you would like to start
is displayed.
4. To start a station, press
within a few seconds.
5. If you wish to stop watering before the pro-
grammed time is up, press
Performing a manual cycle start
The cycle consists of all of the
programmed stations operat-
ing in sequential order.
To manually per-
form a cycle start:
M
B
1. Press until the
Prog A, B or C also appears in the display.
P
2. Press to stop any stations that may be
watering. If a station is in operation, a manual
start is impossible. A station may be in operation
at the module level, but without any irrigation in
19
english
O
. Irrigation will start
P
.
icon is displayed.