Descargar Imprimir esta página

melitta AromaFresh Therm Pro Manual Del Usuario página 19

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 59
Fill the bean container with sufficient coffee
beans and confirm with the "OK" button. The
remaining quantity required will be ground
and the preparation continued.
4.4 Setting number of cups
to be brewed
Set the number of cups to be
brewed with the "Cup + " and
"Cup -" buttons.
Always set the number of cups so it corre-
sponds with the filled quantity of water. The
appliance will then use up all of the water in
the water tank. This setting is used to set the
quantity of coffee beans to be ground. The
brewing process will be optimised for the
quantity set.
4.5 Setting grinding fineness
and brewing strength
The grinding fineness basically influences the
flavour of the coffee. If the grinding fineness is
too fine, the coffee will have a bitter taste. If
the grinding fineness is too coarse, the coffee
will taste acidic.
Turn the "grinding fineness regulator" clock-
wise to set a finer grinding fineness. Turn
it anti-clockwise to set a coarser grinding
fineness.
You use the "Strength" buttons
to set the quantity of coffee
beans being ground. The 0 setting deactivates
the grinder allowing you to use ground coffee.
The grinding results and the brewing strength
can vary between different coffee varieties.
You should try out different settings to obtain
the best results. Always start with a medium
setting.
Note: If, despite setting the grinding fineness
and strength, you do not obtain tasty coffee,
you can also set the quantity of coffee beans
to be ground in the menu under Mill Settings.
Note that this setting influences the taste of
the coffee with all strength levels and with any
number of cups set.
5 Preparing coffee
Observe the following instructions during
preparation:
– Start the preparation with the "Start/
Stop" button. The LED flashes green during
preparation.
– You can end preparation at any time by
pressing the "Start/Stop" button again.
– The brewed coffee flows through the valve
in the lid of the insulated jug.
– The preparation ends automatically. A signal
tone sounds depending on the setting.
– The drip stop in the filter insert stops cof-
fee dripping when you remove the jug.
– Depending on the setting, the screen is
darkened after a few minutes of inactivity.
Press any button to activate the screen.
– To pour the coffee, press down the sealing
lever.
– To open the lid, press the side catches
inwards and pull the lid upwards.
5.1 Preparing coffee with
coffee beans
1. Fill enough coffee beans into the bean
container.
2. Set the grinding fineness.
3. Fit a suitable filter in the filter insert.
4. Fill the water tank according to the
required number of cups.
5. Place the jug with the lid in the appliance.
6.
Set the number of cups to
be brewed.
7.
Set the brewing strength.
The strength may not be 0.
8. Start preparation with the "Start/Stop"
button.
5.2 Preparing coffee with
ground coffee
Use approx. 6 to 8 g of ground coffee per cup.
1. Set the "Strength
" button to 0 to deacti-
vate the grinder.
» The spoon symbol appears on the screen.
2. Fit a suitable filter in the filter insert.
3. Put the required quantity of ground coffee
into the filter.
4. Fill the water tank according to the
required number of cups.
5. Place the jug with the lid in the appliance.
Preparing coffee
19

Publicidad

loading

Este manual también es adecuado para:

Aromafresh therm pro x1030-121030-11