First Steps; Unpacking The Appliance; Setting Up The Appliance; Connecting The Appliance - melitta One Manual Del Usuario

First steps

3 First steps

3.1 Unpacking the appliance

Remove the packaging material and the adhe-
sive strips from the appliance. Please keep the
original packaging.

3.2 Setting up the appliance

Set up the appliance in a dry room.
ƒ
ƒ Set up the appliance on a stable, flat and
dry surface. The surface may not be hot.
The appliance may not be placed in the
vicinity of sinks or the like.
ƒ Route the power cable so it does not lie
over edges or cannot be damaged by hot
surfaces or the hotplate.
ƒ Store the length of cable that you do not
need in the cable-winding facility in the
base of the appliance.

3.3 Connecting the appliance

Only connect the appliance to an easily acces-
sible, properly installed earthed mains socket.
After connecting, all lamps will illuminate
briefly one after the other.
Full isolation from the mains is achieved by
disconnecting the mains plug.
14

3.4 Removing filter

To remove the filter, press the lever (14) and
pull the filter by the filter handle out of the
appliance.
The filter must click in audibly upon inserting.
Place the filter lid on the filter.

3.5 Removing jug

Always hold the jug by the jug handle when
removing and inserting it.
Place the jug correctly on the hotplate so that
the jug lid pushes the drip stop up slightly. This
opens the drip stop and the contents of the
filter can flow into the jug. The drip stop stops
coffee dripping when you remove the jug.

3.6 Filling water tank

The markings on the water tank correspond
with the number of cups that you prepare
during a brewing process. The brewing pro-
cess will always use up all of the water in the
water tank. Therefore, fill only the quantity
of water that you require for the subsequent
brewing process. The filled quantity of water
14