19
TROUBLE SHOOTING
Disconnect the machine from the power supply prior to any checks performed at the
machine itself!
Trouble
Saw stops or will not start
Does not make accurate 45° or
90° cuts
Band wanders during cut
Saw makes unsatisfactory cuts
Band does not come up to
speed
Saw vibrate excessively
Saw band runs in opposite
direction
MANY MALFUNCTIONS AND DEFECTS CAN BE AVOIDED BY LETTING THE MACHINE BE
CONNECTED TO YOUR POWER SUPPLY BY A CERTIFIED ELECTRICIAN
HOLZMANN MASCHINEN GmbH
Possible cause
Overload tripped
Saw unplugged
Fuse blown or circuit breaker
tripped
Cord damaged
Stop not adjusted correctly
Angle pointer not set
accurately
Miter gauge out of adjustment
Fence not aligned with band
Warped wood
Excessive feed rate
Incorrect band for cut
Dull band
Band mounted wrong
Gum or pitch on band
Incorrect band for cut
Gum or pitch on table
Extension cord too light or too
Low shop voltage
Base on uneven floor
Bad v-belt
Bent pulley
Improper motor mounting
Loose hardware
2 of the 3 leading phases are
switched whether in Plug or
socket
www.holzmann-maschinen.at
TROUBLE SHOOTING
Solution
Allow motor to cool and reset
by pushing off switch
Check all power connections
Change fuse or reset circuit
breake
Change cable
Check band with square and
adjust stop
Check band with square and
adjust pointer
Adjust miter gauge
Check and adjust fence
Select another piece of wood
Reduce feed rate
Change band to correct type
Replace band
Teeth should point down
Remove band and clean
Change band to correct type
Clean table
Replace with adequate size
cord
Contact your local electric
company
Reposition on flat level surface
Replace v-belt
Replace pulley
Check and adjust motor
Tighten hardware
Shut off machine immediately.
Let the connection to supply
circuit be corrected by an
electrician!
40
HBS 300J